"High and tight" design is a normal military appearance, usually seen in the Marine Corps. However, there is a version that has the appearance of only subtle differences more intensively in all branches of the service. But seeing this military design, it might be interesting and helpful to find out where the parameters are derived.
Of course, the method of their hair can be worn by people in the ministry is seriously restricted by the military, and to be honest, there are a lot of sense for many causes constraints. But for our purposes, it explains why so many "military haircut" look very similar. Moreover, it gives us insight that leads to the development of "high and tight".
I talked to friends who had been previously in service (Marines) and ask them about haircuts high and tight trim and beginnings. They all basically stating that they are not "real" quotes about them, but they believe the tradition that most of the popularity of this design.
In addition, version feels and wave pattern in the hair styles for men will also need some people to have their hair shorter than many others so you can maintain a very "neat" appearance.
Obviously, this is all conjecture, but it would appear sensible in a unique way.
Make a tight and high Haircut
Tight and high, clear, cut clipper. It is similar in many ways to "high top fade" and "buzz cut" design. Zone is important to take into account the parietal ridge. It could be an idea where the biggest changes occurred long. Hair cut most likely range. Sometimes, trimmer or edger can be used in place of regular scissors so you can reduce the range in the area for a span of less than 1/16 inch. below the parietal ridge Sometimes, clear hair shaved (at least partially) in low areas.
A barber adept, who did this particular slim regularly, generally can make an appearance for your freehand or use a scissor-over-comb.
Begin haircut high and strict guidelines for the longest span utilize your desired. It is possible to put it to use on the bottom of the entire scalp for strengthening the tapering effect, in the event that you want, in the event that you have trimmer by setting a smaller range of scissors naked.
Now, in the "transition zone" set the next longest guide the scissors and cut in the head, stop before you get too far into the best of the head. You will need to have determined "top" before you start this method so that you can have it in mind as to where to stop.
Constantly changing guide you out, working all over the scalp, and will be smaller and smaller. So you keep tapering effect continues to stop short of the previous point that you prefer best. Once you have worked your way through each guide, it is possible to get a fine-toothed comb (comb real barber would be perfect) and pull vertically along the tapered section to find out the "action" that may be left behind on the guide (unless you have successful sailing trims you to combine the range). Use scissors to guide you without caring Clipper off any "points" in the hair. You can even use your scissors with this function.
After tapering continuously mixed, complete the look with a safety razor (or a razor in case you prefer) to "clean" up high and tight haircut. Including the nape, and sideburns.